1·Among these are the rotor shaft, while rotates between a set of bearings.
在这些是转子桥之中，当在一系列举止之间替换的时候。
2·The elasticity of rotor shaft has great influence (403%) on the isolation efficiency of fuselage for prototype.
弹性转子轴的机身为原型的分离效率有很大的影响(403%)。
3·At present, in mostly regulation drive systems, the mostly method is to install a position sensor in the rotor shaft.
当前，在大多数调速驱动系统中，最常用的方法是在转子轴上安装位置传感器。
4·Rotor guide magnet heart is a cylinder with centre hole or a cylinder scraping both sides, and is mounted on rotor shaft.
转子导磁铁心为带有中心孔的圆柱或一削去两边的圆柱，套装在转子轴上。
5·These low frequency spectrum lines are basically the harmonics of the rotor shaft frequency and the blade-passing frequency.
并且这些低频线谱基本上都是转子轴频和叶频的谐波分量。
6·Motor upper and lower guide bearing wear limit, to replace the bearings, rotor shaft eccentric wear limit, to replace bushings;
电机上下导轴承磨损极限，要更换轴承； 转子上下轴套偏磨极限，要更换轴套；
7·A rotor shaft is rotatably mounted at opposite end walls of the reactor and extends through the reactor coaxially with its longitudinal axis.
一可旋转转子轴安装在反应器的另一端墙，并通过反应器同轴扩展其纵轴。
8·EA mounted on the either end of rotor shaft can generate impulse excitation force or simple harmonic excitation force with different frequency.
电磁激振器安装在转子的伸出端，产生脉冲激励力或不同频率的简谐激励力。
9·Rotational movement of the rotor shaft results in a linear output signal that shifts 60 (120 total) degrees around a factory preset null position.
转子的旋转运动和线性输出信号，围绕出厂预置的零位移动60(总共120)度。此输出信号的相位指示离开零位的位移方向。
10·The intake and exhaust shafts are geared to the rotor shaft and have at least one opening each that is aligned with the intake and the exhaust valve ports.
进气轴和排气轴用齿轮连接至转子轴， 并且进气轴和排气轴中的每一个都具有至少一个与进气阀口和排气阀口 对准的开口。